Jenzano Logo
sales@jenzano.com
     Telephone: (386) 761-4474 USA   

Model JCR3PH, JC3PH, JCUA3PH

Weld Control

Features

  • Compact, and simple to operate

  • Separate control, sync transformer

  • Separate firing board modules

  • Front panel mounting plate with universal cons

  • Operator display w/four-button interface

  • Display driven menu programming

  • Fully programmable weld parameters

  • Microprocessor control- no calibration needed

  • Separate Master I/O and slave timing sync boards

  • Watch dog for insured board sanity

  • On board safety relay disconnects valve

  • On board safety relay disconnects firing outputs

  • 25 weld schedule memory

  • EEPROM memory- no batteries to change

  • Program access key lock

  • Power on lamp

  • Front panel mounting plate.

  • Plug in connections to all modules

  • Line filtering and noise suppression

  • Weld  / No weld switch

  • 1, 2 or 3 stage initiation connections

  • Spot or seam control modes

  • On board control fusing

  • Industrial hardened

  • “Non-Beat feature”

  • Multi machine power sharing interlock

  • Operator/ maintenance manual

Photo

Specifications 

  • Control Type (Programmable) 3 phase Freq. Converter, OR 3 phase DC, OR Single phase AC

  • Control voltage 105vac min to 142vac max

  • JCUA voltage    230vac/480vac +- 5%

  • 4 dedicated inputs 120vac 24kohm

  • 4 dedicated outputs 120vac 0.8A ea.

  • Input frequency  60/50 Hz

  • Basic timed periods (in cycles):

    • Up to 3 heat steps per weld temper 
      Preheat, weld, temper: 00 to 99

    • Individual Current decay: 00 to 99 

    • Individual Pulses: 01 to 99 cycles 

    • Individual Cool time: 00 to 99

    • Squeeze time: 00 to 99

    • Hold time: 00 to 99

    • Forge time: 00 to 99

    • Forge delay: 00 to 99

  • % of maximum current:

    • Preheat, weld, temper:  05 to 99%
      Current delay:  05 to 99%

  • Additional set points:

    • Program select:  00 to 99

    • Weld counter:  0000 to 9999

    • LVC:  On/ Off

    • Program pressure:  00 to 99psi

    • K factor time rollover:  01 to 99

    • Type of welder:  Frequency, DC, AC

    • Phase enable (any combo) A, B, C

 

Options

  • Three stage foot-switch

  • Remote panel with Estop, tipdress, no weld

  • Programmable air regulators

  • Integrated valve stack with gauges

  • SCR contactor sizing

  • Power line disconnect

  • Anti-Tie down initiation

  • Set down monitoring

  • Field installation

  • Primary & secondary current monitoring

  • Programmable force

 

Power requirements must be verified at the time of purchase. Specifications are subject to change without notice.  Customer assistance in evaluating proposed application is available.  Photographs shown are typical configurations and do not necessarily represent the standard product.

Link to:    Home  |  Contact